Testing The Towfish Electronics; Figure 4-12: Towfish Electronics Ready For Servicing - Klein 5000 V2 Series Operation And Maintenance Manual

4. Position the post with the threaded hole to the top, and thread the jacking screw
into the post with the long, unthreaded section entering the feed-thru.
5. Tighten the jacking screw to push the electronics into the pressure housing. Stop
when flush.
6. Thread the washer and nut onto the jacking screw and hand tighten.
7. Replace the nose cone.
4.7

Testing the Towfish Electronics

Remove the towfish electronics as described in "Removing the Towfish
Electronics" on page 4-7 and place the electronics in a position so that you can
reconnect the transducers. The towfish electronics is shown removed and ready for
servicing in Figure 4-12.
Testing the Towfish Electronics
CAUTION When tightening the jacking screw as described below, do not
over tighten.
Figure 4-12:
Towfish Electronics Ready for Servicing
4-9