Table of Contents
Advertisement
The Configurator Menu
The Configurator menu appears the first time
you start the terminal, or if you launch the
CFG24 program without parameters.
A-12
shows Configurator menu options.
Note that some terminals do not allow you to
change the
Subnet Mask
addresses.
Terminal IP
If you are using Spectrum24 802.11 protocol-
based software, the menu shows the ESS ID
option. For Spectrum24 Spring protocol-
based software, the menu shows Net ID.
CONFIGURATOR X.XX
View config
ESS Id
Subnet Mask
Default Router
MU IP Address
Diversity
^
CLR, Enter
View Config Parameters
The View config option shows the terminal's IEEE address, IP address, firmware version
number, and ESS ID or Net ID. To display the existing configuration parameters:
1. Select View config.
2. Press CLEAR or ENTER to return to the Configurator menu.
VIEW CONFIG
Terminal IEEE addr
00:A0:F8:28:78:EF
MU IP Address
0.0.0.0
FW: V3.29 981116
Net ID=101
CLR, Enter
Figure
,
Default Router
Figure A-12. The CFG24 Configurator Menu
Figure A-13
Figure A-13. Viewing Configuration Parameters
Configuration Note: Navigating the Menus
To navigate through the menus:
• Press UP or DOWN arrow keys to scroll
through menu options.
• To select, highlight the menu option you
want, then press ENTER. A highlighted op-
reverse video
tion shows up in reverse video .
, and
• To erase part of an entry, press BACK.
• To return to a previous menu press CLEAR.
• To exit to a DOS prompt, return to the Con-
figurator menu and press CLEAR.
shows an example of the screen that appears.
Utilities and Diagnostic Tests
reverse video
A-13
Advertisement
Table of Contents
