Table of Contents
Advertisement
parameters, and press ENTER. The example in
38400, and the COM2 option. For pgmname, type the name of the HEX file you are
transferring, without the .hex extension. The default parameter values are:
" 9600 bps
" COM1
" 7 data bits
" Odd parity
" Xon/Xoff flow control
C:\>cd\
sendhex pgmname 38400 com2
SENDHEX
HEX File Name
Command
(no .hex extension)
Figure 4-2. Setting up Communications with SENDHEX
Note: Versions of SENDHEX earlier than version 3.0 do not support flow
control. If you are using an earlier version, and errors appear, use a
lower baud rate.
5. A prompt appears as shown in
up the VRC 6940 terminal next, as described in the next section.
C:\>cd\
sendhex pgmname 38400 com2
Version: 3.01-01
Press <Enter> when remote is ready. ESC to abort...
Baud Rate
Figure
Figure 4-3. The SENDHEX Prompt
Figure 4-2
COM Port
4-3. Do not press ENTER yet. You must set
Installing Software
shows a baud rate of
4-3
Advertisement
Table of Contents
