Table of Contents
Advertisement
7. To end a Self Test and return to the Self Test menu, press CLEAR. To return to the
Command Mode function menu, press CLEAR again.
Self Test
Config Screen 1 Config Screen 1
Vers: 6940 1.10-00
Time: 09:45:23
Date: 01-01-1980-2
Nicd: Good
Power Src: Charger
COM1: S1 10100
COM2: None
Config Screen 2 Config Screen 2
LCD: 0
KBD ID:00
Wake cause
Memory Screen When the test completes,
these results appear:
Memory Screen 2
ROM CRC: 0 NVM CRC: 10
RAM:0640K
EMS:0000K
Fill Screen
Test Pattern
Set RTC Screen Set RTC Screen
Time: 01:59:13
Date: 01-01-1980-2
Table A-1. Self Test Summary
What You Should See
Main: Good
LCD TYPE:08
GA REV:00
Cmd Mode
Pass
None
• Displays the terminal type and version, time,
date, main and backup battery condition,
current power source, and serial port status.
• Make sure the values shown for Vers, Nicd,
Power Src, and COM1 on the terminal match
those shown here.
• Allows you to perform the keyboard test
described on
• Press CLEAR to return to the Self Test menu.
• Reports keyboard and display information.
• Make sure the values for LCD, LCD TYPE and
KBD ID on the terminal match those shown
here.
• Press CLEAR to return to the Self Test menu.
• Tests ROM, RAM and EMS (Expanded) memory,
and reports the amount of RAM and EMS.
• Takes about one minute to complete.
• Make sure the values shown for CRC match
those shown here.
S
• The RAM test result must be Pass.
• Press CLEAR to return to the Self Test menu.
• The entire screen fills with a test pattern:
make sure that it all displays clearly.
• Press CLEAR to return to the Self Test menu.
• Lets you set the real-time clock (time and
date).
• UP/DOWN arrows change the value at the
cursor. LEFT/RIGHT arrows move the cursor.
• Set the time and press ENTER.
• Set the date and press ENTER.
Format: MM-DD-YYYY
• Press CLEAR to return to the Self Test menu.
Utilities and Diagnostic Tests
Comments
page
A-4.
A-3
Advertisement
Table of Contents
