Table of Contents
Advertisement
Command Mode
To boot to Command Mode:
1. Press the ON/OFF key to suspend the terminal.
2. Press and hold the A and D keys.
3. Press and release the ON/OFF key.
4. Release the A and D keys.
This terminal displays this screen:
COMMAND MODE
Select Function
Self Test
5. Use the UP or DOWN arrows to display other options in place of Self Test. When the
option you want appears, press ENTER to select it.
If warm or cold booting do not clear your problem, but you can boot to Command Mode,
the problem may be:
BIOS and hardware problems: to check the BIOS and hardware, use the Self Test
!
function to check the system hardware (described on page A-2). If there is a
hardware problem, contact Symbol Technical Support.
Application program error: if system hardware is running properly, check for an
!
application error. Perform a Memory Transfer (described on
programmer can perform application-specific troubleshooting. Then install the
correct version of the software as described on
If Rebooting Fails
1. Re-install software following the procedures described in
Software.
2. Contact your authorized Symbol Support representative or Technical Support
Services.
Figure 6-1. Command Mode screen
Troubleshooting
page
page
4-2.
Chapter 4, Installing
6-8) so that a
6-7
Advertisement
Table of Contents
