Ipos 3100 Setup Menu - Symbol iPOS 3100 Product Reference Manual

iPOS 3100 Product Reference Guide

iPOS 3100 Setup Menu

Use the Setup Menu to configure settings on the iPOS 3100. Upon power-up, touch the
screen to display the Setup Menu as the message requests, or do not touch the screen to
select the default settings or previously selected configuration settings.
Submenu
Sound Toggle sound on and off. When on, sound emits when PIN
numbers are pressed and the MSR is swiped.
Brightness Use the slider to adjust LCD brightness.
Host RS-232 Configuration: Select baud rate or Port A, or select
Port B (auxiliary port). Tap Accept or Cancel to return to
the Setup Menu.
RS-485 Configuration: Select RS-485 address, or select
RS-232 (auxiliary port). Tap Accept or Cancel to return to
the Setup Menu.
Note: If changing the RS-485 address, exit the Setup
Menu, turn the iPOS 3100 off, then back on to execute the
change.
Time Adjust the analog clock by increasing or decreasing the
hours and minutes. To set seconds to zero, tap the zero
button, then Done.
Lock Enter a password to prevent other users from changing the
setup. This password is required to make future setup
changes.
Calib Tap the center of the four crosses to calibrate the touchpad.
The Setup Menu re-appears when finished.
Cancel Deletes the values selected on the Setup Menu and exits
setup.
Reset Resets the iPOS 3100 to its default values.
Test Invokes the Test Menu (see
Load Downloads new firmware. The iPOS 3100 autoconfigures
to RS-232 or RS-485 to load the firmware using the
connected cable (see the Host option above).
2-2
Table 2-1. Setup Menu Options
Description
Table 2-2).
Default
On
Mid-scale
Port A at 9600 baud
RS-485 with address
of 68
12:00
Unlock (no password
required)
Uncalibrated