Table of Contents
Advertisement
Topics:
•
Enable administrative communication
•
Accepting the End User License Agreement
•
Run the configuration wizard
•
Configuring additional system parameters
•
Configure HA for new installations
Enable administrative communication
For HA pairs, administrative communication must be enabled on both nodes.
The administrative interfaces are located on the management module on the rear of the chassis. These interfaces are for
management network traffic only. Do not use these interfaces for data traffic.
1. Connect an administrative console to the serial port on the back panel of the system.
2.
NOTE:
You must have 115200 baud rate for the DD9800 system to work properly; 9600 baud rate will not work for the
DD9800 system.
Launch a terminal emulation program from your computer and configure the following communication settings:
Table 27. Communications settings
Setting
Baud rate
Data bits
Stop bits
Parity
Flow control
Emulation
3. Select Enter on your keyboard to activate the console.
NOTE:
If you do not see the prompt on your terminal to log in, then complete Step 4.
4. In the front of theDD9800 system, press the power button to power on the system. Check that the front blue power LED
(with the circle with a dot) also turns on.
80
Configure System for Use
Configure System for Use
Value
115200
8
1
None
None
VT-100
5
Advertisement
Table of Contents
Need help?
Do you have a question about the Data Domain DD9800 and is the answer not in the manual?
Questions and answers