Danfoss DHP-A Installation Instructions Manual page 21

1. There are three M6x20 screws on the lower edge of the outdoor unit. Unscrew them so that 2-3 mm of the
thread remains. Use a torx TX25 screwdriver, or equivalent.
Caution! Do not lift the outdoor unit by its side panels when it is to be raised or moved.
2. Raise the outdoor unit.
3. Remove the side plates. They are held in place by clamps and so are removed by pulling outwards.
4. Remove all four screwed lifting eyes. Use a 13 mm wrench, or equivalent.
4.4.4.3 Assembling the outdoor unit on the stand
1. Lift the outdoor unit into the place on the stand.
2. Screw the outdoor unit onto the stand. Use 4 x M6x20 screws. It may be necessary to push and pull the
stand slightly in order to get the screw holes to align.
Caution! When filling the brine system the outdoor unit must be bled using the bleed screws on
the connecting pipes inside the side covers. We recommend that you return to this instruction after
the brine system has been filled.
3. Reinstall the side panels.
4.4.4.4 Assembling the defrost sensor
Figure 11. Hook the defroster sensor mounting into place
1. Slide the mounting for the defroster sensor into the hole on the reverse of the outdoor unit until the cover
hooks into place on the edge.
2. Take out the defrosting sensor from the electrical connection box. Thread out the sensor through a suitable
lead-in.
3. Route the defroster sensor connection cable through the cable lead-in to the mounting.
4. Secure the defroster sensor at the bottom of the mounting using a cable tie.
4.4.4.5 Assembling the front cover
1. Hook the lower edge of the front cover onto at least one of the three screws in the bottom edge of the
stand.
2. Secure the upper edge of the front panel temporarily in the centre hole. Use 1 x M6x15 torx TX25.
3. Align all the three screws in the lower edge.
4. Screw the three screws in the lower edge fully. Use a torx TX25 screwdriver, or equivalent.
Installation instructions VMBMA1002 – 19