Ecom EN3 Operating Instructions Manual page 59

10.3.2 Data recording with PC Software ecom-DAS 5
The software "ecom-DAS 5" can be used to display and record measured values. Via the MM
card, customer and measurement data can be exchanged between the software and the
instrument. A recording of point and continuous measurements can be done via USB or
WLAN.
Hint
A driver is required to communicate with the PC software DAS 5 via the USB
interface.
Hint
The protocol is pre-defined for the smooth communication of the instrument
with the PC software DAS 5 via USB interface.
Parameter
Transfer speed
Protocol
Hint
For the smooth communication of the device with the PC software ecom-DAS 5
via the interface WLAN, setting parameters are predefined.
Parameter
Access Point
(Without) Auto Connect
Hint
For further information on importing from the PC software and exporting to the
PC software, please refer to the operating instructions of the corresponding PC
software.
ecom-EN3
To download and install the necessary USB driver, see
https://www.ecom.de/en/downloads/
To enable communication with the PC software DAS 5, the
following settings must be made in the menu Adjustments / Internal /
USB:
Meaning
To enable communication with the PC software DAS 5, the
following settings must be made in the menu Adjustments / Internal /
WLAN:
Meaning
Adjustment
1200 ... 115200 Baud
DAS = DAS NT 2
Enhanced = DAS 5
---- = no protocol
Adjustment
Access Point, Existing
Network
Yes, No
Required setting
for DAS 5
1200 ... 38400 Baud
Enhanced
Required setting
for DAS 5
Access Point
Yes
Page 59