Barco OverView D Series User Manual page 73

•
Mind the position of the fingers: the force is to apply on the outer part of the module
•
Press the lamp module tightly into its socket
•
Apply the securing ring on the lamp and press it while turning
•
Turn the securing ring until its hooks click round the guide rods.
•
Close the lamp door
•
Use the hexagon key and lock the lamp door by turning the screw a quarter turn clockwise.
The lamp door must not be open for more than 15 minutes. If not closed within this
period, the projector will show a warning, and then go to standby after another 5
minutes.
If the operation mode of the projector has been Hot Standby, the new lamp is immediately switched on.
Barco - OverView D series - Doc-3353-2 - user's manual - Revision 04 - April 2005
7. Maintenance and servicing
applying the force on the lamp module
_______________________________________________________________________
Figure 7-7
lamp and lamp housing
Figure 7-8
Figure 7-9
inserting the securing ring
7-12