Barco OverView D Series User Manual page 57

6.6.4 Automatic startup
Operation Lamps
To view or switch on/off the Automatic startup, proceed as follows:
•
Use the cursor key to highlight Automatic startup.
•
Press Enter to select.
The currently selected status is indicated by white dot.
 Use the cursor key to highlight the desired status.
 Press Enter to select.
If Automatic startup is ON, the projector will immediately be started after being connected to the mains (power
switch switched on).
If Automatic startup is OFF, the projector will go in Standby mode after being connected to the mains (power
switch switched on).
6.6.5 Standby timer
OverView DG
Operation Lamps
If there is no signal, and the standby timer is enabled, a dialog box is displayed and the projector will shut down
after a determined time (power save).
Message
No signal available.
The projector will go to Standby in 300 sec.
Barco - OverView D series - Doc-3353-2 - user's manual - Revision 04 - April 2005
OverView DG
Status Brightness
Identification
Over Temp Protection
Automatic startup
Standby timer..
Installation
Status Brightness
Identification Identification
Error... Error...
Over Temp Protection... Over Temp Protection...
Automatic startup Automatic startup
Standby timer.. Standby timer..
On
Off
Status menu, Automatic startup
dialog box warning about the projector switching to standby
_______________________________________________________________________
6. Menu structure
Figure 6-29
Figure 6-30
Status menu, Standby timer
Figure 6-31
6-20