Barco OverView D Series User Manual page 43

6.4.6 Source selection
This menu is only available with SXGA+ resolution!
Projection units with SXGA+ resolution feature two DVI-D inputs, thus two sources can simultaneously be con-
nected. The selection of the source to be displayed is done in the Source Selection menu. The following operat-
ing modes are available Manual, Auto, Auto Switch.
•
Use the cursor keys to highlight Source Selection
•
Press ENTER to select.
•
The currently selected status is indicated with a white dot.
•
Use the cursor keys to highlight the desired operating mode
•
Press Enter to select.
Operation Lamps
Background
Message Box
Error Box
Startup screen
Language
Source Selection
Manual
Selecting this command displays a dialog where the source to be displayed can be selected:
Manual Source Selection
Source 1
Source 2
Select the desired Source (Source 1 or Source 2). This source will be displayed. In case this source fails, the
background as selected in Operation | Background (color bar, blue, black) will be displayed, no matter if there is
a signal applied to Source 2 or not. The status of Source 2 has no impact on the behavior.
In this operating mode, the behavior is the same as with one DVI-D input only, except that there is the possibility
to connect two sources and select alternatively one them without the need of re-cabling.
Barco - OverView D series - Doc-3353-2 - user's manual - Revision 04 - April 2005
OverView D
Status Brightness
Manual...
Auto...
Auto Switch...
Operation menu,Source Selection
Operation menu,Source Selection, Manual
________________________________________________________________________
6. Menu structure
Figure 6-7
Figure 6-8
6-6