Barco OverView D Series User Manual page 13

B. Power cord with ANSI 73.11 plug:
The wires of the power cord are colored in accordance with the following code:
Green/yellow:
White:
Black:
•
Do not allow anything to rest on the power cord. Do not locate this product where persons will walk on the
cord.
•
To disconnect the cord, pull it out by the plug. Never pull the cord itself.
•
If an extension cord is used with this product, make sure that the total of the ampere ratings on the products
plugged into the extension cord does not exceed the extension cord ampere rating. Also make sure that the
total of all products plugged into the wall outlet does not exceed 15 amperes.
•
Never push objects of any kind into this product through cabinet slots as they may touch dangerous voltage
points or short out parts that could result in a risk of fire or electrical shock.
•
Never spill liquid of any kind on the product. Should any liquid or solid object fall into the cabinet, unplug the
set and have it checked by qualified service personnel before resuming operations.
Warning: Do Not Place Flammable or Combustible Materials Near Projector!
Barco products are designed and manufactured to meet the most stringent safety regulations. Exposing flamma-
ble or combustible materials into close proximity of this device could result in the spontaneous ignition of that
material, resulting in a fire. For this reason, it is absolutely necessary to leave an "exclusion zone" around all
external surfaces of the projector whereby no flammable or combustible materials are present. The exclusion
zone must be not less than 10 cm (4"). Do not cover the projector with any material while the projector is in
operation.
Keep flammable and combustible materials away from the projector at all times. Mount the projector in a well
ventilated area away from sources of ignition and out of direct sun light. Never expose this product to rain or
excessive moisture. In the event of fire, use sand, CO
electrical fire.
Always have service performed on this product by authorized Barco service personnel. Always insist on genuine
Barco replacement parts. Never use non-Barco replacement parts as they may degrade the safety of this device.
Use only the power cord supplied with your device. While appearing to be similar, other power cords have not
been safety tested at the factory and may not be used to power the projector. For a replacement power cord,
contact your dealer.
Slots and openings in the cabinet and the sides are provided for ventilation; to ensure reliable operation of the
device and to protect it from overheating, these openings must not be blocked or covered. This product should
never be placed near or over a radiator or heat register. This product should not be placed in a built-in installa-
tion or enclosure unless proper ventilation is provided.
Barco - OverView D series - Doc-3353-2 - user's manual - Revision 04 - April 2005
Ground
Neutral
Line (live)
, or dry powder fire extinguishers; never use water on an
2
________________________________________________________________________
1. Preliminary Remarks
1-5