Barco OverView D Series User Manual page 25

Each of this states can be combined with one of the lift positions:
Liftposition
L1
P
L2
up
down
Hot standby
Liftposition
L1 P
up
L2
down
Hot standby
The lamp which output illuminates the optics is called active lamp.
In Hot Standby mode, both lamps are switched on.
In Cold Standby mode (or Auto Switch mode), the active lamp is switched on, the second lamp is switched off.
In projector standby mode, both lamps are switched off.
The status of the projector and of the lamps can be checked by means of the status LEDs on the rear panel of the
projection module, cf. Manual user
The operation mode (Hot Standby, Cold Standby, Auto Switch) can be selected via the IR Remote Control Unit, cf.
Mode.
Hot Standby is only available if especially requested!
The active lamp can be selected via the IR Remote Control Unit (RCU) cf.
standing behind the projection module, the active lamp can also be selected via the manual user interface, cf.
Manual user interface).
Barco - OverView D series - Doc-3353-2 - user's manual - Revision 04 - April 2005
Liftposition
L1
P
L2
up up
down down
Hot standby, Cold standby /
moment of lamp Auto switch
failure
Liftposition
L1 P
up
up
L2
down
down
Cold standby / Hot standby,
Auto switch moment of lamp
failure
interface.
Liftposition Liftposition
L1
P
L2
up
down
Both lamps are
switched off,
projector in standby
Liftposition
Liftposition
P
L1
up
L2
down
Both lamps are
switched off
projector in standby
Active
________________________________________________________________________
3. Design and functions
L1
P
L2
L1 P
L2
Lamp states and lift position
lamp. (When servicing and while
Figure 3-5
3-6