Indicator Led And Cable - IBM Aptiva Series Hardware Maintenance

Indicator LED and Cable

•
Push in on the indicator LED and remove from the rear.
•
Disconnect the LED and cable from the system board.
Figure 4- 24 LED Indicator
Note: LED Cables and Power Switch Cable Install
Please follow the steps below for installation instruction and refer to the diagram.
•
Insert the LED cables along with the power switch cable into the circular
hole (diagram 1).
•
Insert LED cables along with the power switch cable into EMI reduce core
(diagram 2).
•
Encircle the core with LED cables and power switch cable one full turn
(diagram 3).
Repair Information 4-29