IBM Aptiva Series Hardware Maintenance page 58

002 - DOES THE SYSTEM COMPLETE POST WITH ONE SHORT
BEEP AND DOES AN IBM LOGO SCREEN APPEAR? (YES,
READ AHEAD. NO, GO TO STEP 004.)
− Insert the system Bootable Diagnostics Diskette in the diskette
drive. (See "Creating a Boot Disk With Drivers" in "Diagnostic Aids"
on page 3-5 for detail information about making a Bootable
Diagnostics Diskette.)
003 - DOES THE SYSTEM LOAD THE DIAGNOSTIC PROGRAM
FROM THE DISKETTE DRIVE WHEN POWERED OFF AND
THEN ON? (YES, READ AHEAD. NO, GO TO STEP 004.)
− Select Utility on the menu.
− Select Tech Support Form on the menu, press F5 to execute,
then generate a hardware configuration report.
− Compare the system configuration list with the actual devices
installed in the system unit.
Note: If necessary, remove the cover and visually compare the
devices installed in the system unit to those shown in the
hardware configuration report.
− Go to step 006
004 - DO ANY MESSAGES, ERROR CODES, OR SYMPTOMS
APPEAR? (YES, READ AHEAD. NO, GO TO STEP 005)
− Go to "Index of Symptoms, Messages, Error Codes, or Beeps" on
page 2-7.
005 -
− If the keyboard responds incorrectly, go to "Keyboard" on page 2-29.
− If the monitor shows problems, such as jittering, shifting, or being out
of focus, go to "Monitor" on page 2-43 and run the Diagnostics tests.
006 - DOES THE HARDWARE CONFIGURATION REPORT
CORRECTLY IDENTIFY THE DEVICES INSTALLED IN THE
SYSTEM UNIT? (YES, READ AHEAD. NO, GO TO STEP
007.)
− Select Diagnostics from the menu.
− Select All Tests from the menu.
− Go to step 008
Check Procedures 2-5