IBM Aptiva Series Hardware Maintenance page 92

007 -
− Install the failing factory-installed adapter card in a different slot in
the riser card than where originally installed.
008 - DOES THE FEATURE FUNCTION NORMALLY? (YES, GO TO
STEP 019. NO, READ AHEAD.
− Power-off the system unit.
− Check one adapter card at a time. To do this, install one adapter
card in the riser card and power-on the system unit.
− Repeat this with each adapter card if necessary.
009 - IS A WINDOWS 95 DRIVER ERROR DISPLAYED FOR THE
INSTALLED ADAPTER CARD? (YES, READ AHEAD. NO,
GO TO STEP 010)
− Check for proper installation of the adapter card.
− Check all adapter card jumper positions. See "System Board
Layout" on page 5-2.
− Check all cables and connectors on the adapter card for proper
installation.
− Check continuity of any cable attached to the adapter card and
replace if necessary.
− If the problem remains, replace the factory-installed adapter card.
− If the problem remains with a card that was not factory installed,
consult the service information provided by the card manufacturer.
− End
010 -
− Power-off the system unit.
− Reinstall the adapter card and any cables.
− Power-on the system unit without the Diagnostics Diskette inserted.
− Perform the following when the system is running:
Note: If an operating system other than Microsoft Windows 95 is
installed, program screens and icons may differ from these
instructions.
1. Open Microsoft Windows 95 if not already opened by the system.
2. Select the Start icon.
Check Procedures 2-39