Index Of Symptoms, Messages, Error Codes, Or Beeps - IBM Aptiva Series Hardware Maintenance

Index of Symptoms, Messages, Error Codes,
or Beeps
Table 2-1 lists failure symptoms and possible causes. The most likely
cause is listed first. Make sure you complete all items in the cause or
"Action/FRU" column. When servicing a system, always begin with
"Start". This index can also be used to help you decide which FRUs to
have available when servicing a system.
If you are unable to correct the problem using this index, go to
"Undetermined Problem".
Notes:
1. If an error message and incorrect audio response occur, diagnose
the error message first.
2. If you cannot run the Diagnostics tests but did receive a POST
error code, diagnose the POST error message.
3. If you did not receive any error message, look for a description of
your error symptoms in the first part of this index.
4. Check all power supply voltages, switch, and jumper settings
before you replace the system board. Also check the power supply
voltages if you have a system no-power condition. (See "Power
Supply", "System Board Layout"
If you are unable to correct the problem using this index, go to
"Undetermined Problem".
Check Procedures 2-7