IBM Aptiva Series Hardware Maintenance page 61

Table 2- 1 BIOS Error Codes, Messages, and Beeps List
BIOS Error Codes,
Messages, beeps
Note: To diagnose a problem, first find the symptom, message, error
code, or beeps in left column. If directed to a check procedure, replace the
FRU indicated in the check procedure. If no check procedure is indicated,
the first Action/FRU listed in right column is the most likely cause.
010
Memory Error at
XXXX:XXXX:XXXX
011
64KB System
Management Memory
Bad
012
System Management
Memory Not Exist
020
Keyboard Interface Error
021
Keyboard Error or
Keyboard Not
Connected
2-8
Action/FRU
POST Error Codes and Messages
Plug memory module in SIMM socket
properly and reboot system.
Memory module. See the "Step 005" of
"Memory" on page 2-28 to replace
memory module.
System board
Enter BIOS Setup, then reboot system.
Memory module. See the "Step 005" of
"Memory" on page 2-28 to replace
memory module.
System board
Enter BIOS Setup, then reboot system.
Memory module. See the "Step 005" of
"Memory" on page 2-28 to replace
memory module.
System board
Plug keyboard connector properly and
reboot system.
Keyboard
System board
Ensure keyboard and mouse are connected
in their own connectors without mix-up.
Plug keyboard connector properly and
reboot system.
Keyboard
System board