Water Hardness Level; Test Run - Hanseatic WQP12-7635 User Manual

5. In order to equalise unevenness in the
floor and set up the dishwasher on a level
horizontal base, you can screw the four
adjustable feet in or out. There are slots
in the appliance feet around the circum-
ference. Insert a screwdriver and turn the
appliance foot.
Use a spirit level to set up the dishwasher.

Water hardness level

Hard water will cause calcification within the
dishwasher. Also, more dishwasher deter-
gent will be required to clean the dishes. Soft
water increases foaming.
For this reason, the degree of hardness of
the water has to be determined and adjusted
even before the first use. You can determine
the water hardness from your water bill or
enquire about the degree of hardness at the
water supply company. The appliance is fac-
tory-set to a hardness level of "H3".
Adjusting the water hardness
level
(9)
(10)
1. Close the dishwasher door.
2. If the dishwasher is switched on, switch it
off.
Do not allow more than 1 minute to elapse
between the following steps, otherwise the
setting process will be interrupted.
1. Switch on the dishwasher using the
button (1).
2. Press and hold the
LEDs (9) and (10) flash alternately.
Setup or under-worktop installation and connection
(13)
button (13) until
Please refer to the following table for the
relevant water hardness setting:
°dH LED display
0-5
6-11
12-17
18-22
23-34
35-55
3. Press the button (13) repeatedly until
the required hardness level is displayed.
4. Around 5 seconds after you push it for the
last time, the dishwasher will automatical-
ly revert to the normal display.
The hardness level setting is saved.

Test run

It is recommended that you carry out a test
run before the first dishwasher cycle in order
to remove residues from the manufacturing
process and in order to ensure that the de-
vice functions perfectly. Carry out this test run
when the dishwasher is empty and without
any dishwasher detergent.
1. Open the valve completely.
2. Close the dishwasher door.
3. Press the button (1) to switch on the
dishwasher.
You will hear a signal tone and all LEDs
will illuminate briefly.
After a moment, the ECO programme
LED will light up.
Page EN-25
Setting
H1
H2
H3
H4
H5
H6