Substructure - Hanseatic WQP12-7635 User Manual

Page EN-24 Setup or under-worktop installation and connection
earthed power socket with its own fuse of
a sufficient size (230 V~/50 Hz/10 A).
– The plug must be installed in such a way
that the recess into which the dishwasher
will be fitted is deep enough even when the
plug is plugged in.
– Do not use a multi-socket extension cable,
multi-socket plug, travel adapter, extension
cable or similar.
– We recommend using a pulse-sensitive re-
sidual current device (RCD).
• Connect the mains plug to the socket.

Substructure

NOTICE
Risk of damage!
Selecting the wrong screws can dam-
age the worktop.
Select the correct screws with the ap-
■
propriate screw length.
Use the enclosed screws.
■
59.8 cm
Requirements
– Only install the dishwasher underneath a
continuous worktop which is joined to the
units adjacent to the dishwasher.
– Maintain sufficient distance from the walls
and adjacent appliances. The measure-
ments of the recess must at least corre-
spond to the details in the diagram above.
1. Remove cardboard, polystyrene and ad-
hesive strips from the inside of the dish-
washer, if you have not already done so.
2. Loosen both screws on the reverse side
of the covering panel and remove them.
3. Affix the enclosed condensation-protec-
tive film (c) to the bottom of the work sur-
face. In this way, you will avoid damage to
the work surface as a result of hot steam
84.5 cm
which may be emitted from the dishwash-
er if the dishwasher door is left open.
4. Place the dishwasher in the desired posi-
tion.
60.0 cm
(c)