Water Hardness Level - Hanseatic WQP8-7636 User Manual

2. Loosen both screws on the reverse side
of the covering panel and remove them.
(c)
3. Affix the enclosed condensation-protec-
tive film (c) to the bottom of the work sur-
face. In this way, you will avoid damage to
the work surface as a result of hot steam
which may be emitted from the dishwash-
er if the dishwasher door is left open.
4. Place the dishwasher in the desired posi-
tion.
5. In order to equalise unevenness in the
floor and set up the dishwasher on a level
horizontal base, you can screw the four
adjustable feet in or out. There are slots
in the adjustable feet around the circum-
ference. Insert a screwdriver and turn the
appliance foot.
Use a spirit level to set up the dishwasher.
Setup or under-worktop installation and connection

Water hardness level

Hard water will cause calcification within
the dishwasher. Also, more dishwasher de-
tergent will be required to clean the dishes.
Soft water increases foaming.
For this reason, the degree of hardness of
the water has to be determined and adjusted
even before the first use. You can determine
the water hardness from your water bill or
enquire about the degree of hardness at the
water supply company. The appliance is fac-
tory-set to a hardness level of "H3".
Adjusting the water hardness
level
(9)
(10)
1. Close the dishwasher door.
2. If the dishwasher is switched on, switch it
off.
Do not allow more than 1 minute to elapse
between the following steps, otherwise the
setting process will be interrupted.
1. Switch on the dishwasher using the
button (1).
2. Press and hold the
LEDs (9) and (10) flash alternately.
Please refer to the following table for the
relevant water hardness setting:
°dH LED display
Page EN-25
(13)
button (13) until
Setting