Sony HDCU1000 Installation Manual page 70

How to adjust using the VCS-700
In the system with the MSU-900/950, CNU-700 or VCS-
700, the video output signal of HDCU1000/1080/1500 can
be checked on the waveform or vector monitor connected
to the WF A OUTPUT connector and the WF B OUTPUT
connector of the VCS-700.
Connect the WF OUT connector of the VDA-64A/64B
board to the WF 1 connector of the VCS-700 and connect
the PIX OUT connector to the PIX 1 connector. Then
adjust the signal level using the color bar signal.
1. Press the BARS button of the MSU-900/950, RCP-
750/751, etc., or press the ENC button of the WAVE-
FORM MONITOR buttons (or MONITOR SELECT
buttons) to display the color bars on the waveform or
vector monitor.
2. Set the CONTROL switch of the VCS-700 to RESET.
3. Adjust the color bars signal using the WFM 1 LEVEL
and WFM 1 CHROMA controls of the VCS-700 so
that it is within the specified level.
Measurement point : PIX OUT connector on the VCS-
700
A = 100 ± 1 IRE [for NTSC]
Specification :
A = 700 ± 7 mV p-p [for PAL]
(WFM 1 LEVEL control)
[for NTSC]
A
Each luminescent spot on the vector monitor must be
within the "4" range.
(WFM 1 CHROMA control)
[for NTSC]
R
M
G
Y
L
B
G
C
Y
2-26 (E)
[for PAL]
A
[for PAL]
R
M
G
Y
L
B
G
C
Y
How to adjust using the MSU-900/950
The signal level can be adjusted by using the MSU-900/
950 instead of using the controls of the VCS-700.
1. Press the MAINTENANCE button of the MODE
block of the MSU-900/950 so that the button lights.
The maintenance menu is displayed.
Maintenance Menu
Adjusting CAM SW Auto
Setting Setup
Lens VCS
Adjusting Adjusting
SD SuperMotion
Adjusting Setting
2. Press [VCS|Adjusting].
The VCS monitor level adjustment item menu is
displayed.
Clear
Monitor
Level
VCS Monitor Level
Low Middle High
WF Level WF Chroma
3. Adjust the color bars signal of the WF Level and WF
Chroma so that it is within the specified level.
Measurement point : PIX OUT connector on the VCS-
700
A = 100 ± 1 IRE [for NTSC]
Specification :
A = 700 ± 7 mV p-p [for PAL]
(WF Level)
[for NTSC]
A
Exit
Home
1
1
Chara-
100%
cter on
[for PAL]
A
. IM/HDCU1000 Series