Sony HDCU1000 Installation Manual page 21

Ref.No. Name
S407 TEST
1
2
3
4
*
5 Ethernet
6
7
8
S408 MODE2
1 NP-SEL AUTO/N
2
3 GRAY LINE/ON
4 MONI/SYNC
5 CAM PWR
BACKUP *1
6
7
8 CO-AX DIS/ENB
S409 CCU-NO
1 to 4
5 to 8
S410 HD-SD DLY
S411 SEQ1&SEQ2
* : This function has been added to software V1.10 and the later versions.
*1 : This function has been added to software V1.20 and the later versions.
. IM/HDCU1000 Series
Function
Factory use
Factory use
Factory use
Factory use
Ethernet connection setting
ON : Ethernet connection can be set.
OFF : Ethernet connection cannot be set.
Factory use
Factory use
Factory use
SD-Format setting
ON : Forced into NTSC (525).
OFF : For AUTO, follows the setting of 1.000 (=PAL) /1.001 (=NTSC).
Not used
Gray signal output setting
ON : During Gray signal output, when turning CB ON/OFF, the Gray image
disappears, leaving only the Line signal.
OFF : During Gray signal output, even when turning CB ON/OFF,
the Gray signal is output.
For switching signals between the CHARACTER/SYNC output in HDCU1500
ON: Outputs SYNC. (Switch between HD and SD with S412)
OFF: Outputs a character monitor signal.
ON: Creates a backup when the CAMERA POWER ON/OFF is operated
from a remote control panel.
OFF: Starts at CAMERA POWER ON.
Not used
Not used
Factory use
CCU No. setting
S409-4 to 1: 1' digit (BCD)
S409-8 to 5: 10' digit (BCD)
Video phase setting between HD and SD
Sets the phase difference (delay time) between HD signal and SD signal
output from CCU.
Can switch the delay settings among 0-DLY, LINE-DLY, and FRAME-DLY.
0-DLY : Same-phase mode of HD-SD (excluding 24PsF)
LINE-DLY : Sets the minimum delay amount of D/C. SD signal delays as
much as 90H (1080i) or 120H (720P).
FRAME-DLY : Sets the frame delay amount. SD signal delays as much as
1 frame (1080i) or 2 frames (720P).
* 90H is the level frequency of 1125-60i/50i, and 120H is that of 720-60P/50P.
n
If the format setting of the camera is set to 24PsF when the 0-DLY mode is set,
the setting is treated as Frame-DLY.
The phase difference between the HD-60 signal that underwent 2-3 Pull-Down
and the SD signal that underwent D/C from that is 1 frame (2 frames for 720P).
Switch depending on the waveform monitor to be used.
+ : PNP : PNP open collector output
_ : NPN : NPN open collector output
Factory default setting
OFF
OFF
OFF
OFF
ON
OFF
OFF
OFF
OFF
OFF
OFF
OFF
_
_
OFF
_
OFF (ALL)
OFF (ALL)
LINE-DLY
(+)
1-15 (E)