Service Parameters - Promatic WDC10B Manual

SERVICE PARAMETERS

Service parameters are divided into the following groups: S1 - general settings, S2 - settings
for the first heating circuit, S3 - settings for the second heating circuit, S4 - settings for do-
mestic hot water, S5 - settings for boilers in S6 - settings for alternative energy sources.
Service parameters enable you to choose among various additional functions and adapta-
tions of controller's operations.
When you select the desired parameter group, a new screen appears:
Parameter
mark.
Factory set
value of the
HY DRA UL I C S CHE ME
parameter.
You can change the setting by pressing the
setting, so a new screen appears for the entry of unlocking code:
The factory set code is »0001«.
You can change the parameter value with buttons
by pressing the
and , and repeat the procedure.
Exit parameter settings by pressing the
Only a trained professional shall perform the changing of service and function
parameters.
Service setting manual
Use buttons
wish to change and press the
When the number begins to flash, you can change it
with buttons
pressing the
tered, the controller will unlock the parameters and re-
turn to the menu with the selected group of parameters.
Exit the unlocking code entry by pressing the
button. Now you can move on to another parameter with buttons
- Parameter is locked.
Parameter value.
MIN is the minimum possible setting of parameter.
MAX is the maximum possible setting of parame-
ter.
Parameter description.
button. Parameters are locked by factory
and
and
button. When the correct code is en-
and
button.
38
to find the number you
button.
and confirm it by
button.
. Confirm the selection