Operating Mode Selection - Promatic WDC10B Manual

OPERATING MODE SELECTION

In the menu, select the desired operation mode of the controller separate for each heating
circuit and for d. h. w. warming. You can select operation modes from the menu for the fol-
lowing:
The first heating circuit
The second heating circuit *
Domestic hot water
Switch-over between heating and cooling
Manual operation of outputs
Chimney sweep
O
Operation mode according to day temperature
The controller operates according to the desired day temperature.
Operation mode according to night temperature
The controller operates according to the desired night temperature.
Switch-off
The controller is switched off, while frost protection remains active, if operation
mode heating is selected, or protection against overheating (30 °C), if operation
mode cooling is selected.
O
D. h. w. warming according to selected time program
D. h. w. is warmed according to the selected time program.
Permanent activation of d. h. w. warming
D. h. w. warming functions continuously.
Switch-off
D. h. w. is not being warmed.
* The menu is only available by schemes with two heating circuits.
User manual
Operation according to selected time program
Operation proceeds according to the selected time program. If room
unit is switched on, the icon
cates which room unit influences the circuit). If the controller functions
without room unit, only the
. . .:
or appears (The number indi-
icon will appear.
26
: