Service Setting Manual; Controller Parameters; User Parameters - Promatic WDC10B Manual

CONTROLLER PARAMETERS

All additional settings and adaptations of the controller's operations are performed with the
help of parameters. User, service and function parameters are available on the second menu
screen.
In each group, only the parameters used in the selected hydraulic scheme can
be seen. Factory set values of parameter settings also depend on the selected
hydraulic scheme.

USER PARAMETERS

User parameters are divided into the following groups: P1 - general settings, P2 - settings for
the first heating circuit, P3 - settings for the second heating circuit, P4 - settings for domestic
hot water, P5 - settings for boilers, and P6 - settings for alternative energy sources.
When you select the desired group of parameters in the menu, a new screen appears:
Parameter mark.
Graphic display of
the setting.
Parameter
description.
You can change the Settings by pressing the
The setting value will begin to flash. Now you can change it with buttons
Confirm the setting by pressing the
Now you can move on to another parameter with buttons
procedure.
Exit the parameter settings by pressing the

SERVICE SETTING MANUAL

button.
33
Current parameter value.
Last confirmed setting value.
Factory set value.
Setting range.
Current parameter value.
button .
and
button.
and .
, and repeat the
Service setting manual