Replacing An Existing Communicator; Register By Phone - Honeywell IntelliPath Series Installation And Setup Manual

Section 4: Registration

Replacing an existing communicator

Enter PIN#
Registering ...
Registration
SUCCESS
Registration BAD

Register by Phone

You can register the communicator by calling the AlarmNet Technical Assistance Center (TAC) at
1-800-222-6525. You will need the following information:
 MAC number (found on the label).
 Subscriber information (provided by the central station), including a city code, CSID, and a
subscriber ID.
 When instructed to do so, triple-click the TEST / REGISTRATION switch to complete the
registration.
This prompt appears after pressing the [Shift] and down arrow [] on
the 7720P.
NOTE: If it is necessary to exit registration mode, press ESC from the
7720P programming tool.
Enter a 4-digit alphanumeric PIN number provided by your central
station, your dealer or an authorized AlarmNet representative.
Press the [Enter] key.
The registration message is sent and the unit waits for
acknowledgement.
If the PIN is valid, the new communicator is registered and the old unit
unregistered. Additionally, AlarmNet sends a substitution alarm to the
central station.
If you entered an invalid PIN, the appropriate message is displayed
depending on which account number is being replaced (see above for
exact wording). The registration process is repeated.
NOTE: Each attempt causes a substitution alarm to be sent to the
central station.
19