Honeywell IntelliPath Series Installation And Setup Manual page 28

Operating with 3G Service
[E]
RAT RSCP
3G -xxx -xxxxxx
RSCP MIN
xxxx xxxx
Cntry Netw
xxx xxx
Cell Chan
xxxxxx xxxx
Second Site RSSI
Available
[F] NOTE: The Network Diagnostic Test is available only if the Comm Path Choice is "IP&Cell" or "IP".
Testing Gateway
Redir 1
Signal Display for 3G
EC/No
RAT – Radio Access Technology.
RSCP –Received Signal Code Power
Ec/N0 – Carrier Noise Ratio (CNR)
Press the [space] key to get to the next screen.
Press the [backspace] key to go to the previous field.
Min/Max Signal Display for LTE
MAX
RSRP – Current Reference Signal Received Power
xxxx
MIN – Minimum Receive Signal Level
MAX – Maximum Receive Signal Level
Press the [space] key to get to the next screen.
Press the [backspace] key to go to the previous field.
Location Display for 3G
LAC
Cntry – Country Code
xxxxx
Netw – Network Code
LAC – Local area code
Press the [space] key to get to the next screen.
Press the [backspace] key to go to the previous field.
Cell Display for 3G
PSC
Cell – Global Cell ID
xxx
Chan – Control Channel in use
PSC – Primary Sync Code
Press the [space] key to go to the next screen.
Press the [backspace] key to go to the previous field.
3G Status Display Screen 5
Secondary Site RSSI availability. Available or Not Available will be
displayed.
Press the [space] key to go to Status Display Screen 1.
Press the [backspace] key to go to the previous field.
Run Network Diagnostic Test
Performs a set of network diagnostics that tests the integrity of the links
between the communicator and the various connection points (Redirs) to
AlarmNet. Refer to Section 6: Network Diagnostics.
LTE-CF Installation and Setup Guide
24