Adjusting The Seat Height With Quick Release; Height-Adjustable Seat Post - Bosch BULLS Twenty 6 EVO Translation Of The Original Operating Instructions

6.5.1.3 Adjusting the seat height with quick
release
1 Open the quick release on the seat post to
change the seat height (1). To do so, push the
clamping lever away from the seat post (3).
3
4
Figure 48: Opening the seat post quick release
2 Set the seat post at the required height.
CAUTION
!
Crash caused by an excessively high seat post
setting
A seat post with is set too high will cause the seat
post or the frame to break. This will cause a crash
with injuries.
 Do not pull the seat post out of the frame
beyond the minimum insertion depth marking.
3
4
Figure 49: Detailed view of the seat post – examples of the
minimum insertion depth marking
3 To close it, push the seat post clamping lever as
far as it will go into the seat post (2).
4 Check the clamping force of quick releases.
MY20B01 - 52_1.0_02.10.2019

6.5.1.4 Height-adjustable seat post

Only applies to pedelecs with this equipment
Preparing
1 When using your seat post for the first time,
2
 Once you have displaced the post through its
1
Lowering the saddle
5
Figure 50: The seat post lever can be installed either on
the left (1) or right (2) side of the handlebars
1 Press your hand down on the saddle or sit on
2 Press the seat post lever and hold it down.
3 Release the seat post lever once you have
Raising the saddle
1 Press the seat post lever and hold it down.
2 Remove any pressure from the saddle.
2
3 Release the seat post lever once you have
1
you must give it a firm push downwards to set
it in motion. This is due to the natural tendency
of the seal to repel oil from the seal surface.
You only need to do this before the first use or
after a longer period of non-use.
deflection, the oil spreads on the seal and the
post begins to function normally.
1
the saddle to lower the saddle.
reached the required height.
reached the required height.
Operation
2
50