Table of Contents
Advertisement
Water connection
Information about the water supply
The appliance may only be
connected to the water supply by a
suitably qualified technician.
Disconnect the appliance from the
power supply before connecting it to
the water supply.
Turn off the water supply before
connecting the water supply line for
the ice cube maker.
The water quality must conform to
the requirements for drinking water in
the country in which the appliance is
being installed (e.g. 98/83/EU).
The appliance must only be
connected to the mains drinking
water supply.
This appliance meets the requirements
of IEC 61770 and EN 61770.
This appliance must be installed in
accordance with AS/NZS 3500.1 and
AS/NZS 3500.2. Back flow
prevention is already integrated in
the appliance.
Use the hoses supplied with the
appliance. Old or used hoses must not
be connected to the appliance.
The appliance is only suitable for
connection to a cold water line,
which
– is directly connected to the fresh
water mains in order to ensure
sufficient circulation and therefore
good water quality.
Avoid connection to a water supply
in which the water might stagnate.
This can affect the taste of water and
ice cubes.
– withstands the operating pressure.
– complies with hygiene regulations.
The water pressure must be between
1.5 and 6 bar (150 and 600 kPa).
The stainless steel hose supplied is
1.5 m long and must not be lengthened.
A faulty stainless steel hose must
only be replaced by an original Miele
replacement hose (available from
Miele). The water hose must be
suitable for drinking water.
A tap must be provided between the
stainless steel hose and the household
water supply to ensure that the water
supply can be disconnected if
necessary.
Make sure that the tap is still
accessible after the appliance has
been installed.
Connecting the water supply
Disconnect the appliance from the
power supply before establishing the
mains water connection.
Installation
69
Advertisement
Table of Contents
