Installation; Installation Site - Miele FN 4712 E ws Operating Instructions Manual

Table of Contents

Advertisement

Installation

Installation site

Risk of damage due to high hu-
midity.
In environments with high humidity,
condensation can build up on ex-
ternal refrigeration appliance panels.
This condensate can cause corrosion
on external appliance panels.
Install the refrigeration appliance in a
dry and/or air-conditioned room with
sufficient ventilation.
After installation please make sure
that the appliance door(s) closes/
close properly and that the specified
ventilation gaps are adhered to.
Fire risk and risk of damage from
appliances which give off heat.
Appliances which give off heat can
catch fire and set fire to the refrigera-
tion appliance.
Do not place appliances which give
off heat, such as mini-ovens, double
burner hobs or toasters on the refri-
geration appliance.
Fire risk and danger of damage
from open flames.
Open flames can set fire to the refri-
geration appliance.
Keep open flames (e.g. a candle)
away from the refrigeration appli-
ance.
14
This appliance should be installed in a
dry, well-ventilated room.
When deciding on the installation site,
please bear in mind that your refriger-
ation appliance will use more energy if
installed near to a heater, a cooker or
other appliance that gives off heat.
Avoid direct sunlight.
The higher the ambient temperature,
the longer the compressor runs and
the higher the energy consumption is.
When installing the refrigeration appli-
ance, please note the following:
- The socket must be easily accessible
in an emergency, not concealed be-
hind the appliance.
- The mains plug and mains connec-
tion cable must not touch the rear of
the refrigeration appliance as they
could be damaged by vibrations from
the appliance.
- Do not plug in other appliances into
sockets behind this appliance.
- Do not position or operate multi-
socket adapters, distributor strips or
other electronic devices (such as
halogen transformers) at the rear of
the appliance.
- The floor at the installation site must
be horizontal and level and must be
as high as the surrounding floor.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Fn 4722 e wsFn 4742 e wsFn 4772 e wsFn 4322 e

Table of Contents