Installation Of The Rvon-1 Card - RTS KP-32 User Instructions

KP-32 User Manual

Installation of the RVON-1 Card

Before using the RVON-1 card with the KP-32, a few modifications need to be made to the keypanel. If the serial number on
your KP-32 keypanel is 61170, you must to update you back panel with the Ethernet RJ-45 connection (part number - 9080-
7656-002) knockout present. Also, the KP-32 flash chips need to be replaced with larger flash chips (4MB) see Table 4 on
page 80.
To install the RVON-1 card, do the following:
Remove the cover from the KP-32 keypanel.
1.
If present, remove the GPI/O board.
2.
The GPI/O board contains the general purpose input and output connections located on the back cover.
Using a chip extractor, carefully remove and replace the flash chips located at U2 and U3 on the KP-32 Motherboard.
3.
Using a hammer and screwdriver, remove the specified knockout pieces.
4.
Mount the supplied spacer on the RVON-1 card on the corner of the card near the DIP switch. Securely connect the
5.
RVON-1 card to the KP-32 motherboard.
Replace the GPI/O board.
6.
Re-attach the back plate to the KP-32 keypanel. Be sure to secure the spacer with a screw in the back plate.
7.
Replace the cover on the KP-32 keypanel.
8.
NOTE: In the KP-32 keypanel, the RVON-1 card connects to the KP-32 by way of the J2 connector on the RVON-1,
attached to J4 on the KP-32 header.
Bosch Security Systems, Inc. User Manual
81
F.01U.193.253 Rev. 16