1. Manuals
  2. Brands
  3. RTS Manuals
  4. Intercom System
  5. KP-12
  6. Installation instructions manual

RTS KP-12 Installation Instructions Manual

Gpi module
Hide thumbs Also See for KP-12:
Table of Contents

Advertisement

Quick Links

See also: Instructions for Using , Instruction and Installation Manual

Installation Instructions

KP-12 GPI Module
9330-7497-007 Rev B
O
O
P
P
T
T
O
O
4
2
O
O
P
P
T
T
O
O
3
1
O
C
R
1
E
L
A
Y
O
2
C
2
R
E
L
A
Y
1
November 2005

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the KP-12 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for RTS KP-12

Summary of Contents for RTS KP-12

  • Page 1: Installation Instructions

    Installation Instructions KP-12 GPI Module 9330-7497-007 Rev B November 2005...
  • Page 2 ROPRIETARY OTICE The product information and design disclosed herein were originated by and are the property of Telex Communications, Inc. Telex reserves all patent, proprietary design, manufactur- ing, reproduction, use and sales rights thereto, and to any arti- cle dislcosed therein, except to the extent rights are expressly granted to others.

  • Page 3: General Description

    Remove and discard the long, blank panel section from the back panel of the KP-12. Or, if the KP-12 already has a Rear Connector Module installed, remove the short blank panel section from the center of the back panel.

  • Page 4: External Device Connections

    Connector pin-outs are listed on page 6. Two sets of contacts are provided for relays, each with NC (normal closed) and NO (normal open) contacts. Sample connections for the OC outputs and the OPTO inputs are shown in the figures below. KP-12 Before Rear Connector Module Installation Plastic Spacers GPI Module...

  • Page 5: Operational Notes

    Relays and the OC1/OC2 Outputs Relays and the OC outputs can be assigned to keys using LOCAL I/O in the KP-12’s KEY ASGN menu. Not, the GPI module relays are desingated s LRY1 and LRY2 (local relay 1 and 2) to distinguish them from intercom system relays (RY1, RY2, ect).
  • Page 6 30VDC may be used. NOTE: The KP-12 Foot Switch must be connected at J6 (Opto-4 &Opto-3) on the back of the KP-12. It also must be cabled across pins 5 & 9 of the Opto-4 & 3 DB-9 connector (see Figure 4).
  • Page 7 Operational Notes C Cable Routing Showing Connection to GPI Module. FIGURE 5.
  • Page 8 KP-12 GPI Module Installation Instructions Reconnector Module Pin-outs : All connectors are DE9P, 9-pin male D- NOTE Relay 1 (J2) Pin 1 NC contact 1a Pin 2 NO contact 1a Pin 3 COM contact 1a Pin 4 NC contact 1b...
  • Page 9 Reconnector Module Pin-outs...
  • Page 10 12000 Portland Avenue South • Burnsville, MN 55337 • U.S.A www.telex.com...

Table of Contents