Chapter 2 Installation; Installation Of The Rvon-1 Card - RTS KP-32 User Manual

Installation of the RVON-1 Card

Before using the RVON-1 card with the KP-32, a few modifications need to be made to the keypanel. If the serial number on
your KP-32 keypanel is 61170, you will need to update you backpanel with the Ethernet RJ-45 connection (part number -
9080-7656-002) knockout present. Also, the KP-32 flash chips need to be replaced with larger flash chips (4MB) see Table 2,
"Flash Chip replacement part numbers.," on page 4.
To install the RVON-1 card, do the following:
Remove the cover from the KP-32 keypanel.
1.
If present, remove the GPI/O board.
2.
The GPI/O board contains the general purpose input and output connections located on the back cover.
Using a chip extractor, carefully remove and replace the flash chips located at U2 and U3 on the KP-32 Motherboard, see
3.
"Flash Chip Replacement" on page 4.
Using a hammer and screwdriver, remove the specified knockout pieces, see Figure 2..
4.
Mount the supplied spacer on the RVON-1 card on the corner of the card near the DIP switch. See Figure 3 on page 6.
5.
Securely connect the RVON-1 card to the KP-32 motherboard , see page X for connector specifics.
6.
Knock out positions for the RVON-1 card on the KP-32
Figure 2.
CHAPTER 2
Installation
5