Basic Operation; Screen Saver Operation; Selecting Headset Or Speaker; Listen Volume Adjustments - RTS KP-32 User Instructions

Screen Saver Operation

If the KP-32 is set for screen saver operation, the alphanumeric display automatically shuts off after several minutes of
inactivity. The display reactivates on incoming call or when the keypanel operator actuates any control. DIP switch 3 enables/
disables screen saver operation.
NOTE: You can override the normal timeout period for screen saver operation and immediately place the keypanel in
screen saver mode. See "Service Menu, Disply Dim" on page 45.

Selecting Headset or Speaker

Tap the Headset/Vol. Sel. key upward. The Vol. Sel. display alternates between Hdst and Spkr with each key tap. The Headset
LED lights when the headset is selected and is off when the speaker is selected.

Listen Volume Adjustments

By default, the Vol. control adjusts the listen volume for the speaker or headset, whichever appears in the Vol. Sel. display. The
level of auxiliary program inputs 1 & 2 (if GPI/O board is present and Aux inputs are enabled) and the level of incoming audio
from the intercom matrix can be adjusted. To adjust a level, press the Vol. Sel. button until the desired source appears in the
Vol. Sel. display (Aux1, Aux2, or Icom). Then, use the Vol. control to adjust the listen volume. The Vol. control defaults back
to the speaker or headset after about one minute of inactivity of the control. The minimum volume level for either the keypanel
speaker or headset may be adjusted. See "Service Menu, Min Volume" on page 51.
NOTE: You can save the volume adjustments to be the power-up defaults using "Service Menu, Save Cfg" on page 53.
Bosch Security Systems, Inc.
User Manual
CHAPTER 3

Basic Operation

F.01U.193.253 Rev. 16