Connections; Exp And Lcp Connectors; Frame Connector - RTS KP-32 User Instructions

KP-32 User Manual

Connections

EXP AND LCP Connectors

Connect from the Exp. connector on the back of the KP-32 to the Expansion 1 connector of an optional EKP-32 Expansion
Panel. Use the interconnect cable supplied with the Expansion Panel. The Expansion 2 connector on the Expansion Panel can
connect to a second Expansion Panel, but no more than 64 intercom keys can be operated per intercom port.
Each LCP-32/16 adjusts the listen levels for 16 keypanel keys, and you can connect as many LCP-32 panels as required to
adjust all keys on the KP-32 and on an optional EKP-32 Expansion Panel. An interconnect cable is supplied with each
LCP-32. Connect the first LCP-32 to the LCP connector on the KP-32. Connect the second LCP-32 to the first LCP-32, and so
forth.
NOTE: When arranging LCP-32 panels in an equipment rack, you should put them directly above or below the keys the
unit is used to adjust.

Frame Connector

Use either of the Frame connectors (but not both) to connect to an intercom port of the intercom system. The intercom port you
connect to should agree with the address that you set previously. Cable wiring diagrams are shown in Figure 19 and Figure 20.
DE9S Intercom Cable Wiring
FIGURE 19.
RJ12 Intercom Cable Wiring
FIGURE 20.
Bosch Security Systems, Inc. User Manual
Installation 13
F.01U.193.253 Rev. 16