Call Signal Option Card Installation - RTS DSI 2008 User Instructions

Call Signal Option Card Installation

To install a Call Signal Option Card in a DSI 2008 that was originally ordered without it, do the following:
Disassemble the DSI 2008 as previously described.
1.
Assemble the standoffs to the circuit board using the supplied screws and lock-washers.
2.
Connect the supplied power cable from J8 on the option card to J303 on the main board of the DSI 2008.
3.
Insert the connectors on the option card into the connectors on the main board.
4.
Use the remaining screws and lock-washers to secure the standoffs to the main board.
5.
Reassemble the DSI 2008.
6.
The Call Signal Option Card after installation in the DSI 2008.
FIGURE 11.
21