SECTION 4: OPERATING THE ACCORD
Setting and Unsetting the system
Before setting the system:
• Ensure all doors and windows are secure.
• Ensure that none of the movement detectors are obstructed.
Full Set [1]
To Full Set the system:
• Enter your User Code then press the 1 (Full Set) key.
• A constant exit tone is heard which changes to a broken tone as you pass the
detectors (except Final Exit zones) on the exit route.
• The Day LED will flash during the Exit Time.
• To cancel the setting procedure press the
• Once the system sets two confirmation beeps are emitted by the keypad and
internal speaker; after this the
Easy Set – allows users to Set the system without entering their User Code. If Easy
Set is programmed you may set the system by pressing the # key, then the 1 (Full
Set) key. See
SECTION 3: Programming the Accord; Group 4 — Option 8 Easy Set
Part Set [2]
To Part Set the system:
• Enter your User Code then press the 2 (Part Set) key.
• This starts the setting of the system using the Part Set zone programming.
This allows a sub-set of the system to be set.
• The Day LED will flash during the Exit Time.
• To cancel the setting procedure press the
• Once the system sets two confirmation beeps are emitted by the keypad and
internal speaker†; after this the
† The activation of the keypad buzzer and internal speaker are dependant on the
programming of Programming Group 4 — Option 4 Part Set Exit Warning.
Easy Set – allows users to Part Set the system without entering their User Code. If
Easy Set is programmed you may set the system by pressing the # key, then the 2
(Part Set) key. See
.
Set
SECTION 3: Programming the Accord; Group 4 — Option 8 Easy
(Escape) key.
(Escape) key does not function.
(Escape) key.
(Escape) key does not function.
22
.