Download  Print this page

Connections To The Accord; Mounting And Wiring The Led Remote Keypad - Honeywell Ademco Accord Installation Instructions Manual

Hide thumbs

Advertisement

Connections to the Accord

Mounting and Wiring the LED Remote Keypad

To mount and wire the Accord LED keypad:
1.
Press down the two base clips recessed on
top of the keypad while gently pulling the two
halves of the case apart.
2.
Route the wiring from the Control Panel
through the Cable Entry Hole on the back
case. Use Knockout Holes A or B if
alternative routes are necessary. Tip: Use a
knife to help dislodge knockouts.
3.
Securely mount the back case to a wall or
electrical box via the mounting holes. Ensure
The Tamper Tab is securely screwed down.
4.
The remote keypad PCB should be wired to
the control panel PCB as outlined in Table
2.1 LED Keypad Wiring.
5.
Re-attach the keypad front to the back case
by inserting the hinges on the keypad front
into the hinge retainers on the bottom of the
keypad back case. Gently apply pressure to
the keypad front until the two retaining tabs
click firmly into place.
Note: The keypad voltage should be at least 12.5V
Keypads can be wired to the control panel independently, in series, or in a star
configuration. Up to four keypads can be connected.
P
a
n
l e
K
A
x u
+
A
x u
K
P '
A
D
Table 2.1 LED Keypad Wiring.
8
Mounting Holes
Base Clip
Cable Entry
Hole
Hinge Slot
Mounting Holes
Fig 2.3 Accord LED Keypad
e
y
p
a
d
+
e v
e v
k
p
a
d
Knockout
Hole A
Base Clip
Tamper Tab
Screw Hole
Hinge Slot
Knockout
Hole B

Hide quick links:

Advertisement

loading