Avaya Communication Server 1000 Installation And Commissioning Manual page 140

WLAN IP Telephony Manager 2245 configuration
changed. It is automatically set by the system. Reset the WLAN IP Telephony Manager
2245 at exit to clear Maintenance Lock.
• Inactivity Timeout—use this option to configure the number of minutes that the
administrative module can be left unattended before the system closes it. This number
can be from 1 to 100. If the number is 0, the administrative module does not close due to
inactivity.
• QoS Configuration—use this option to configure decimal values, from 0 to 63 (default
4), for all classes of traffic.
Table 22: Cisco QoS settings
Administration
WT (In Call)
WT (Standby)
RTP
PBX
Inter-SVP
Table 23: Avaya QoS settings
Administration
WT (In Call)
WT (Standby)
RTP
PBX
Inter-SVP
To ensure the system transmits voice packets efficiently and with minimal delay, you must
configure the decimal value for voice packets higher than the value for data packets. The
configurable classes are:
- Administration—used for Telnet, TFTP and other administrative traffic. This class
can have the lowest priority because it does not require voice quality.
- WT (in call)—traffic requires voice quality. Configure this class with a higher priority
than WT (standby).
- WT (standby)—traffic requires voice quality. Configure this class with a lower priority
than WT (in call).
- RTP—traffic is audio traffic to IP PBX; it requires voice quality.
- PBX—traffic is not audio traffic to the PBX; voice quality is not required.
140 Avaya WLAN IP Telephony Installation and Commissioning
4 (default)
46
26 (can also be 46 if using PTT)
46
26
46
4 (default)
46
40 (can also be 46 if using PTT)
46
40
46
November 2010