SMART Board MX (V2) Series Installation And Maintenance Manual page 4

IMPORTANT INFORMATION
If the glass is broken, do not touch the liquid crystal. To prevent injury, handle glass
l
fragments with care when disposing of them.
Do not move or mount the display by connecting rope or wire to its handles. The display is
l
heavy, and failure of the rope, wire or handle could lead to injury.
Use only VESA®-approved mounts if using a mount other than the one supplied with the
l
display..
Disconnect all of the display's power cables from the wall outlet and seek assistance from
l
qualified service personnel if any of the following occur:
The power cable or plug is damaged
o
Liquid is spilled into the display
o
Objects fall into the display
o
The display is dropped
o
Structural damage, such as cracking, occurs
o
The display behaves unexpectedly when you follow operating instructions
o
Before inserting or removing an OPS from the display, turn off the display using the switch at
l
the back of the display. See
information.
CAUTION
Turn off the display before cleaning its screen. Otherwise, you may scramble the desktop
l
icons or inadvertently activate applications when you wipe the screen.
Avoid setting up and using the display in an area with excessive levels of dust, humidity, and
l
smoke.
Make sure an electrical socket is near the display and remains easily accessible during use.
l
The display should be used only with European TN and TT power distribution systems.
l
It is not suitable for older, IT-type power distribution systems found in some European
countries. This system (IT-type) is widely used isolated from earth, in some installations in
France, with impedance to earth, at 230/400V, and in Norway, with voltage limiter, neutral
not distributed, at 230V line-to-line.
Contact qualified personnel if you're uncertain of the type of power system available where
you're installing the display.
ii smarttech.com/kb/171555
Open Pluggable Slot computer (OPS) disclaimer for more