Stone Set Installation - Rinnai Ember Series Installation Manual

Stone set installation

The stone set is packaged separately. Use extreme care when handling the stones,
they are made from fragile material and will damage easily. While the stone sets
for the Ember 600 and 700 are different (Ember 600 has six less stones), the
installation steps are the same. Refer to p. 20 for the correct installation order.
Ember 600
3
Ember 700
3
Before adding the stone set make sure the vermiculite and glass packets have been added into
the burn media tray (refer p.21), and that it has been secured back in place. Also remove the two
back log locating pins and bracket (not needed for the stone set)—replace the black screws
holding the bracket back into the burner.
Back log location pin and bracket
24 | Ember Installation Guide: 12890-B 02-18
1
2
4
1
2
Step 1: Back row of stones
Place the back row of stones as shown.
Ember 600 Ember 700
Step 2: Middle row of stones
Place the middle row of stones BETWEEN the burner ports as shown.
Ember 600 Ember 700
Step 3: Front row of stones
Add the front row of stones inside the grill. A few of these will be angled slightly to cover the
front of the burner bed.
Ember 600 Ember 700
Step 4: Adding the granules and rockwool
Place, DO NOT POUR, the granules, ensuring even coverage around the burner ports (so as not to
cause blockages). You will use approx. one bag of granules for both models (a bag will be leftover).
Pinch and roll the rockwool into pea-sized balls (600 ≈ 20, 700 ≈ 30) and place in-between the
granules. These can go over the burner ports as the material is designed for the flame to penetrate
through the ceramic fibres to enhance the flame picture and produce a glow effect.
Ember Installation Guide: 12890-B 02-18 | 25