Wacker Neuson DPU80 Series Operator's Manual page 46

9 Maintenance
3. Unscrew the fuel cap of the fuel tank and remove it.
4. If necessary, remove and clean the dirty fuel filter. Reinsert fuel filter before topping up.
5. Top off fuel to the limit mark – for fuel type, see Technical Data chapter.
6. Replace fuel cap and tighten.
7. Close rear protective hood.
NOTICE
Dispose of impurities of the fuel filter in accordance with the applicable provisions for
environmental protection.
9.4.2 Clean machine and remote control
WARNING
Risk of fire and explosion when using flammable cleaning agents.

NOTICE
Permeating water can damage the engine, electrical operator's controls, or components
of the machine and remote control. Do not aim high pressure washer directly at air intake
area and electrical elements. Clean remote control with only a damp cloth.
1. After cleaning, check switches, levers, cables, hoses, pipes and hardware for leaks, loose
connections, abrasions and other damage.
2. Immediately eliminate detected damage.
9.4.3 Check engine oil level and top off engine oil
1
2
Item Designation
1 Cover of the oil filler opening
Check engine oil level
1. Open both protective hoods.
2. Remove dirt accumulation in the area of the oil-level dipstick.
3. Pull out oil-level dipstick.
4. Wipe oil-level dipstick with a dry, lint-free cloth.
5. Fully reinsert oil-level dipstick
6. Pull out oil-level dipstick.
7. Check whether the oil is between the lower and upper mark of the oil-level dipstick.
Top off motor oil
1. Remove dirt accumulation in the area of the oil filler opening.
2. Remove cover of the oil filler opening.
46
Do not clean machine, components, or operator's controls with gasoline or other
solvents.
Item Designation
2 Oil-level dipstick
100_0202_mt_0011.fm