Setting The Autonegotiation Mode - Sun Microsystems GigaSwift Ethernet Adapter Installation And User Manual

To list all the parameters supported by the ce driver, type ?.
See through
TABLE 4-1
# ndd /dev/ce
name to get/set ? ?
?
instance
adv_autoneg_cap
adv_1000fdx_cap
adv_1000hdx_cap
adv_100T4_cap
adv_100fdx_cap
adv_100hdx_cap
adv_10fdx_cap
adv_10hdx_cap
adv_asmpause_cap
adv_pause_cap
master_cfg_enable
master_cfg_value
use_int_xcvr
enable_ipg0
ipg0
ipg1
ipg2
rx_intr_pkts
rx_intr_time
red_dv4to6k
red_dv6to8k
red_dv8to10k
red_dv10to12k
tx_dma_weight
rx_dma_weight
infinite_burst
disable_64bit
accept_jumbo
name to get/set ?
#

Setting the Autonegotiation Mode

By default, autonegotiation is set to on. This means that the adapter communicates
with its link partner to determine a compatible network speed, duplex mode, and
flow control capability.
for parameter descriptions.
TABLE 4-12
(read only)
(read and write)
(read and write)
(read and write)
(read and write)
(read and write)
(read and write)
(read and write)
(read and write)
(read and write)
(read and write)
(read and write)
(read and write)
(read and write)
(read and write)
(read and write)
(read and write)
(read and write)
(read and write)
(read and write)
(read and write)
(read and write)
(read and write)
(read and write)
(read and write)
(read and write)
(read and write)
(read and write)
(read and write)
(read and write)
Chapter 4 Configuring Driver Parameters 49