Table of Contents
Advertisement
Refer to the documentation that came with your switch for exact commands to
configure jumbo frames support.
Jumbo Frames With Trunking 1.3
When using jumbo frames with Trunking 1.3, you must explicitly enable jumbo
frames on each link participating in the Trunk.
To Configure Jumbo Frames Using ndd
1. Bring down and unplumb the interface.
2. Set the instance number:
% ndd -set /dev/ce instance 0
In this example, the instance number set is 0.
3. Set the instance to accept jumbo frames:
% ndd -set /dev/ce accept-jumbo 1
4. Plumb the interface up:
% ifconfig ce0 plumb xx.xx.xx.xx up
Where
Setting ce Driver Parameters
You can set the ce device driver parameters in two ways:
Using the ndd utility
Using the ce.conf file
If you use the ndd utility, the parameters are valid only until you reboot the system.
This method is good for testing parameter settings.
46
Sun GigaSwift Ethernet Adapter Installation and User's Guide • August 2004
= the IP address of the interface.
xx.xx.xx.xx
Advertisement
Table of Contents
Troubleshooting
