Table 4-5 Parameters Defining Enable_Ipg0 And Ipg0; Table 4-6 Read-Write Interpacket Gap Parameter Values And Descriptions - Sun Microsystems GigaSwift Ethernet Adapter Installation And User Manual

If enable_ipg0 is disabled, the value of ipg0 is ignored and no additional delay is
set. Only the delays set by ipg1 and ipg2 will be used. Disable enable_ipg0 if
other systems keep sending a large number of back-to-back packets. Systems that
have enable_ipg0 set might not have enough time on the network.
You can add the additional delay by setting the ipg0 parameter from 0 to 255, which
is the media byte time delay.
TABLE 4-5
TABLE 4-5
Parameter
enable_ipg0
ipg0
The ce device supports the programmable Interpacket Gap (IPG) parameters ipg1
and ipg2. The total IPG is the sum of ipg1 and ipg2. The total IPG is 0.096
microseconds for the link speed of 1000 Mbps.
TABLE 4-6
TABLE 4-6
Parameter
ipg1
ipg2
By default, the driver sets ipg1 to 8-byte time and ipg2 to 4-byte time, which are
the standard values. (Byte time is the time it takes to transmit one byte on the link,
with a link speed of 1000 Mbps.)
If your network has systems that use longer IPG (the sum of ipg1 and ipg2), and if
those systems seem to be slow in accessing the network, increase the values of ipg1
and ipg2 to match the longer IPGs of other machines.
42 Sun GigaSwift Ethernet Adapter Installation and User's Guide • August 2004
defines the enable_ipg0 and ipg0 parameters.
Parameters Defining enable_ipg0 and ipg0
Values
0
1
0 to 255
lists the default values and allowable values for the IPG parameters.
Read-Write Interpacket Gap Parameter Values and Descriptions
Values
(Byte-time)
0 to 255
0 to 255
Description
enable_ipg0 reset
enable_ipg0 set (Default=8)
The additional time delay (or gap) before
transmitting a packet (after receiving the
packet) (Default=8)
Description
Interpacket gap 1 (Default = 8)
Interpacket gap 2 (Default = 4)