Sun Microsystems GigaSwift Ethernet Adapter Installation And User Manual page 32

2. List the network devices on your system.
ok show-nets
You should see the full path name of the network devices, similar to the example
below. In this example, the network@0 and the network@1 devices are the Sun
GigaSwift Ethernet adapter, and the network@2 is the onboard Ethernet device.
ok show-nets
a) /pci@8,600000/network@1
b) /pci@8,700000/network@5,1
q) NO SELECTION
Enter Selection, q to quit:
/pci@8,600000/network@1 identifies the Ethernet port
Note – If you do not see the device listed, check that the adapter is properly seated.
If necessary, reinstall the adapter.
3. View the device that you installed.
Using the previous example, type:
cd /pci@8,600000/network@1
10 Sun GigaSwift Ethernet Adapter Installation and User's Guide • August 2004