Sun Microsystems GigaSwift Ethernet Adapter Installation And User Manual page 121

The following procedure describes how to turn autonegotiation off for one
SunSwitch port.
1. Establish a connection to the switch using either a serial connection or a Telnet
connection.
Refer to the SunSwitch 1.1 Installation and Configuration Guide (805-3743-10) for more
information. After connecting to the switch, the Main menu prompt (Main#) is
displayed.
2. At the Main# prompt, type cfg to display the Configuration menu and prompt
(Configuration#).
>> Main# cfg
[Configuration Menu]
sys
port
ip
vlan
stp
snmp
setup -
dump
>> Configuration#
3. Type the following to disable autonegotiation on a GigaSwift Ethernet port.
Replace portnumber with the Ethernet port used by the adapter.
>> Configuration# /port portnumber/auto off
4. Type the following to apply and save your changes.
>> Configuration# apply
>> Configuration# save
Refer to the switch documentation for further configuration instructions.
- System-wide parameter menu
- Port configuration menu
- IP addressing menu
- VLAN configuration menu
- Spanning Tree menu
- SNMP menu
Step by step configuration set up
- Dump current configuration to script file
Appendix D Diagnostic Software and Troubleshooting Issues 99