Table 4-13 Transmit And Receive Parameters - Sun Microsystems GigaSwift Ethernet Adapter Installation And User Manual

Gigaswift ethernet adapter
Table of Contents

Advertisement

If the link partner is not capable of autonegotiation (when lp_autoneg_cap is 0),
the remaining information described in
value = 0.
If the link partner is capable of autonegotiation (when lp_autoneg_cap is 1), then
the speed and mode information is displayed when you use autonegotiation and the
link partner capabilities.
TABLE 4-13
TABLE 4-13
Parameter
xcvr_inits
rev_id
xcvr_addr
xcvr_id
lb_mode
qos_mode
tx_starts
tx_dma_bind_fail
tx_queue0
tx_queue1
tx_queue2
tx_queue3
tx_max_pend
rx_hdr_pkts
rx_mtu_pkts
56
Sun GigaSwift Ethernet Adapter Installation and User's Guide • August 2004
describes the netstat -k transmit and receive parameters:
Transmit and Receive Parameters
Description
Number of physical layer re-initializations every time you change
link parameters using NDD this increments.
Revision ID of the GigaSwift Ethernet device useful for recognition
of device being used in the field.
GMII/MII physical layer device address for management interface.
GMII/MII physical layer device Identification Decimal copy of MII
registers 2 and 3.
Copy of the Loopback mode the device is in, if any.
When zero, the TX queues operate in a simple round robin
queueing scheme, based on TCP/UDP destination port number. If
set the TX queues operate in a scheme designed to provide VLAN
priorities.
Number of times that the driver attempted to transmit a packet.
Number of times a page table entry was not available to enable the
driver to map the kernel memory to device accessible memory for
transmission.
Number of packets queued for transmission on the first hardware
transmit queue.
Number of packets queued for transmission on the second
hardware transmit queue.
Number of packets queued for transmission on the third hardware
transmit queue.
Number of packets queued for transmission on the fourth hardware
transmit queue.
Maximum number of transmits pending on any of the four queues.
Number of packets received that were less than 256 bytes.
Number of packets received that were greater than 256 bytes and
less than 1514 bytes.
is not relevant and the parameter
TABLE 4-12

Advertisement

Table of Contents
loading

This manual is also suitable for:

GcsGfs

Table of Contents